RepRap + SPaRC

RepRap Prusa Mendel Project (RAMPS 1.4 Board)

The electronics setup that I decided to go with for this RepRap build was the RAMPS 1.4 platform. I ordered the RAMPS 1.4 DIY Kit Complete from Ultimachine with optical endstops and the pre-soldered SMT components. I did feel that it was worth $15 of my time and frustration trying to figure out how to solder all of those tiny parts, and I think it was a good choice. Perhaps the next build will involve using the re-flow oven, but that’s another story. (more…)

Read More